Site Information

 Loading... Please wait...

Rak Installation

After you have received your raks you'll need the following tools and equipment to install them correctly and safely.

1- Your going to need a black/white marker, a Phillips head screw driver, a 6mm masonary drill bit (for anka screws 8mm), a Drill and a hammer.

2-Position the raks on the wall and using a marker scribe the hole position to suit the rak. If you have bricks the centre of the brick is best not into the mortor.

3-Drill your holes 45mm deep.

4-Using the hammer tap the wall plugs into position.

5-Postion the rak and using the supplied screws attach to the wall using clutch power of the drill do not over tighten.

6-After the rak is mounted you can rak up your boards.